Agri-Fab 45-04631 Manuel d'utilisateur télécharger pdf (Page 7)

FIGURE 15

STEP 15: (SEE FIGURE 14)

• Slide a 5/8" washer (O), a spacer (L), a 5/8" washer

(O) and a wheel onto the end of the axle with no hole.

• Carefully hammer a hub cap (Z) onto the axle.

FIGURE 14

STEP 13: (SEE FIGURE 13)

• Fasten the hopper braces (11) to the hopper support

tubes using the nylock nuts (J) that were assembled

earlier. Do not tighten completely.

• Fasten the loose ends of the hopper braces to the

hitch tube using a 1/4" x 2" hex bolt (C) and a 1/4"

nylock nut (J). Do not tighten completely.

STEP 14:

• Tighten all bolts and nuts except for those shown in

step 10 that fasten the control bracket to the hitch tube.

FIGURE 13

SETTING "5"

OFF

FIGURE 16

STEP 17: (SEE FIGURE 16)

• Set the adjustable stop at "5" and move the control

hande back against it.

• Slide the control bracket along the hitch tube until the

owplateinthebottomofthehopperisopenhalfway.

• Tighten the bolts and nuts fastening the control

bracket. Do not deform the control bracket.

• Makesuretheowplatewillopenandcloseallthe

way. Readjust if necessary.

STEP 16: (SEE FIGURE 15)

• Slide a 5/8" washer (O), a spacer (L), a 5/8" washer

(O) and a wheel onto the end of the axle with a hole.

• Attach the wheel to the axle with a 3/16" x 2" cotter

pin (R).

• Carefully hammer a hub cap (Z) onto the axle.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Agri-Fab 45-04631 Manuel d'utilisateur Page 7