Agri-Fab 45-04631 Manuel d'utilisateur télécharger pdf (Page 5)

STEP 5: (SEE FIGURE 5)

* install the gearbox by inserting the end of the verticle

shaft into the cross brace bushing and inserting the

axle into the ends of the hopper support tubes. Be

sure the hole in the axle is located on the side shown

in figure 5.

hole on this end

STEP 7: (SEE FIGURE 7)

* Place the hopper on the hopper support tubes,

inserting the spreader shaft up through the square

hole in the bottom of the hopper.

* Slide the hopper bushing (X) onto the spreader shaft

and insert it into the bottom of the hopper.

* Slide the spacer (K) onto the spreader shaft.

* installthe agitator hairpin (S) in the spreader shaft.

FIGURE 5

STEP 6: (SEE FIGURE 6)

* Slide the fiat sided bearings (W) onto the axle and

insert them into the ends of the hopper support tubes.

* Slide the spreader impeller (12) onto the spreader

shaft and secure it with a 1/8" x 1-1/2" cotter pin (Q).

FIGURE 7

STEP 8: (SEE FIGURE 8)

* Attach the hopper to the hopper support tubes using

four 1/4" x 1-3/4" hex bolts (D), 1/4" washers (M),

nylon washers (N) and 1/4" nylock nuts (J). Make only

finger tight.

* insert the 1/4" x 1" hex bolt (F) into the hole in the

bottom of the hopper, pressing the head of the bolt

into the hex shaped recess of the hole. install a 1/4"

nylock nut (J) onto the bolt and tighten.

FIGURE 6

/ /

..... o o _ e

// /

_u I)

FIGURE 8

1 2 3 4 5 6 7 8 9 10 ... 19 20

Pas de commentaire

Agri-Fab 45-04631 Manuel d'utilisateur Page 5