ADJUSTING THE FLOW RATE SETTING
1. Loosen the wing nut that fastens the control to the
2. Slide the Adjustable stop to the desired setting and
retighten the wing nut. See fi gure 5.
1. This unit will cover a 4 to 8 foot wide area depending
on the material used and the towing speed.
2. To avoid misses or striping, make each pass about 5 feet
from the previous one so some overlapping of spread
3. For easiest application, spread across the shortest
edges of lawn fi rst, making two "header" strips for a
turning area, and then spreading between the header
4. If lawn is odd shaped, spread a border around the edges
and then spread between the border. See fi gure 6.
5. Keep wheel approximately 4 feet from any area you do
Be careful when using spreader around
ornamental plants because weed control chemicals can
1. Check the material package and the Spreader Settings
sheet included with your spreader for the proper spreader
setting and application rate.
2. Before fi lling spreader, move the control lever to the
3. Move spreader onto a fl at surface - either a walk or a
Slide the Adjustable Stop to the desired setting.
Start the spreader in motion, then move the control
lever forward against the adjustable stop to begin
Maximum towing speed - 3 M.P.H.
Always place control lever in the "OFF" position while
fi lling spreader and when stopping or turning, to prevent
CHECK FOR LOOSE FASTENERS
Make a thorough visual check of the Spreader for any
bolts and nuts which may have loosened. Retighten any
Apply a few drops of oil to all moving parts.
Always empty spreader after each use, storing leftover
material in it's original bag.
Wash the spreader and dry thoroughly after each
Empty and clean the hopper as instructed in maintenance
2. Store in a clean, dry area.
FLOW CONTROL LEVER
ADJUSTABLE STOP
Commentaires sur ces manuels